Сделал простой скрипт для управления температурой кулера Raspberry Pi.
- Зачем? Их же полно готовых! Даже дефолтные инструменты есть.
Хотелось сделать этот велосипед по-своему 😁
▫️Пороговых температур две: Одна контролирует момент включения, другая выключения. Например, выше 80 - включаем. Остыл до 50 - выключаем.
▫️ Значения пороговых температур заипсывается в специальном файле и считывается каждый раз при проверке темературы без рестарта сервиса.
Исходники и схема.
https://github.com/paulwinex/rpi_fan_control
ЗЫ. В схеме присуствует сопротивление. Это требуется только если нужно уменьшить скорость вращения кулера. Мой на полных оборотах сильно гудит, пришлось поставить.
#sources#rpi
#FLM/USDT analysis :
#FLM is forming higher highs (HHs) and higher lows (HLs) along the trendline support. The price has recently swept through the swing low stop losses and is now expected to move upward, resuming its bullish direction to test the swing high resistance level.
TF : 2H
Entry : $0.0423
Target : $0.0445
SL : $0.0409
#FLM/USDT analysis :
#FLM is currently in a bearish trend on the higher time frame. A retracement towards the 200 EMA is anticipated as the price forms a higher high structure. It is expected to move upward and test previous highs.
TF : 1H
Entry : $0.0584
Target : $0.0636
SL : $0.0560
#FLM/USDT analysis :
#FLM is currently in a downtrend, trading below the 200 EMA. The price is consolidating sideways within a support and resistance zone. It is currently facing rejection at the resistance zone and is expected to decline from this point, testing the support zone.
TF : 1D
Entry : $0.0620
Target : $0.0500
SL : $0.0700
#FLM🧐
👉EMA Confluence
👉Failure Swing
👉MACD
The second chart fully and automatically generated by our algorithm.
All drawings are based on only mathematical values and calculations instead of emotions.
Interested?
Check out -> www.coinlegs.com / www.legslabs.com